Mac Address Table Settings - D-Link DGS-3630 Series Reference Manual

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
To view the following window, click L2 Features > FDB > Static FDB > Multicast Static FDB, as shown below:
The fields that can be configured are described below:
Parameter
From Port - To Port
VID
MAC Address
Click the Apply button to accept the changes made.
Click the Delete All button to remove all the entries.
Click the Delete button to remove the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

MAC Address Table Settings

This window is used to display and configure the global MAC address table settings.
To view the following window, click L2 Features > FDB > MAC Address Table Settings, as shown below:
The fields that can be configured are described below:
Parameter
Aging Time
Aging Destination Hit
Click the Apply button to accept the changes made.
Figure 5-2 Multicast Static FDB Window
Description
Select the range of ports that will be used for this configuration here.
Enter the VLAN ID of the VLAN the corresponding MAC address belongs to.
Enter the static destination MAC address of the multicast packets. This must be
a multicast MAC address. The format of the destination MAC address is 01-XX-
XX-XX-XX-XX.
Figure 5-3 MAC Address Table Settings (Global Settings) Window
Description
Enter the MAC address table aging time here. This value must be between 10
and 1000000 seconds. Entering 0 will disable MAC address aging. By default,
this value is 300 seconds.
Select to enable or disable the aging destination hit function.
53