Gigabit Ethernet Ports - Proxim Edge MP-1015-CPE Hardware Installation Manual

The features of the above devices are tabulated as below:
A detailed description about the various components of the device are explained in the following sections.
Item
1 Ethernet Port
2 Grounding Point
3 5 GHz Antenna Ports (A1 and A2)
4 5 GHz Antenna Ports (A3 and A4)
Edge 1015 and 1025 only
5 GPS Connector
Edge 1015 and 1025 only
6 RSSI Display
7 Mounting Holes
8 Hose Clamp Slits
Important: Edge device includes a dual polarization 15 dBi panel antenna which is enabled by default. To use
external antenna instead, switch to external antenna mode via BlueConnect application or via Web
GUI. Refer to the antenna switching procedure in the Device Management Guide.

3.1.1 Gigabit Ethernet Ports

The device comes with one 1000 BASE-T ethernet port with configurable Tx modes and speeds.
Ethernet Port/ PoE IN and Data
•
The Gigabit Ethernet Port (PoE IN and Data) of the device allows the user to connect to the LAN by using Cat5e Ethernet
cable, and also power ON the device by using the Power over Ethernet (PoE) Injector supplied with the product package.
The device receives (36 - 57) V DC via a STP Cat5e cable connected between the PoE and the device.
•
TM
Edge Multipoint and Quickbridge - Hardware Installation Guide
Features Description
• PoE IN and Data
• Debugging and Management
• A provision to ground the device.
• A provision to connect external antenna in MIMO 2x2
mode.
• Connect A1 to antenna Vertical Polarity port and
A2 to antenna Horizontal Polarity port.
• A provision to connect external antenna in MIMO 4x4
mode (in addition to A1 and A2).
• Connect A3 and A4 to antenna Slant Polarity ports.
Notes: MIMO 4x4 operation requires license
upgrade.
• A provision to connect passive GPS antenna for device
positioning.
• Displays boot up information (see Signal LED
Behavior section).
• Displays RSSI signal level from weak (1 LED) to Strong
(5 LED) once the RF link is established.
• A provision to connect 1000-UMK mounting kit
(provided with Edge 1015 and 1025) or 10000-UMK
mounting kit (optional).
• A provision to attach hose clamps (1/2 inch or 12 mm
width) for pole mounting.
Device Overview
9