Table of Contents
Advertisement
:
• When you configure a host name instead of an IP address, ensure that you configure DNS server IP on the
device.
• IPv6 address should be the global IP address and not the link-local IP address.
•
Time Zone: Configure the time zone from the available list. This configured time zone is considered before setting the
time, received from the time servers, on the device.
•
Day Light Saving Time: Configure the Day Light Saving time from the available list. This configured Day Light Saving
time is considered before setting the time, received from the time servers, on the device.
•
ReSync Interval: Once the time is synchronized, the SNTP Client tries to resynchronize with the time servers after
every set time interval.
•
Sync Status: Specifies the SNTP Client sync status when it tries to ReSync again with the time servers. The status is as
follows:
• Disabled: The SNTP client will not synchronize the time with the time servers and displays the status as Disabled.
• Synchronizing: The SNTP client is in the process of synchronizing time with the time servers.
• Synchronized: The SNTP client has synchronized time with the time servers.
•
Current Date/Time: Specifies the system current date and time.
• If SNTP is not enabled, the current date and time are automatically generated by the local system.
• If SNTP is enabled, it displays the time, that the device has obtained from the SNTP server.
•
Manual Time Configuration: Manually set the time if the SNTP Client is disabled on the device or the time servers
are not available on the network.
:
• Reboot does not retain Manual Time Configuration. Set the time again after every reboot.
• It is recommended to periodically check and adjust the time since the device may lag behind the actual time
with the Manual Time Configuration.
Click OK and Commit, to save the configured parameters.
5.5 Access Control
The Access Control tab enables you to control the device management access through specified host(s). You can specify a
maximum of five hosts to control device management access.
Navigate to Management > Access Control, configure the parameters. Click OK and Reboot the device, if you have
changed the values in the Access Control Table.
Add or Edit Host(s) to Management Access Control Table
To add a host to the Management Access Control Table, do the following:
1. Click Add in the Management Access Control screen.
2. IP Address: Based on the IP mode, configure either IPv4 or IPv6 address of the host that controls the device
management access.
3. Entry Status: By default, the entry status is enabled meaning which the specified host can control the device
management access. Edit the status to Disable, if you do not want the host to control the device management access.
4. Click Add.
You can also edit the desired host entries.
After configuration, click OK, Commit and then Reboot.
Device Management Guide
Device Management
36
Advertisement
Table of Contents
