DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
disable mld_snooping
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the MLD snooping:
config mld_snooping
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure mld snooping:
121
To disable MLD snooping on the Switch.
disable mld snooping
The disable mld snooping command disables MLD snooping on
the Switch.
None
Only administrator or operator-level users can issue this command
DGS3100# disable mld_snooping
Success.
DGS3100#
To configure mld snooping.
config mld_snooping [<vlan_name 32> | all] {host_timeout <sec
60-16711450> | router_timeout <sec 1-16711450> | done_timer
<sec 0-16711450> | state [enable | disable]}
The config mld_snooping command defines mld snooping on the
VLAN.
vlan_name 32 – specifies that the mld snooping applies only to this
previously created VLAN.
all – specifies that MLD snooping is to be configured for all VLANs
on the Switch.
host_timeout – Specifies the maximum amount of time a host can be
a member of a multicast group without the Switch receiving a host
membership report. The default is 260 seconds.
router_timeout – Specifies the maximum amount of time a route can
be a member of a multicast group without the Switch receiving a
host membership report done timer. The default is 300 seconds.
done_timer – Specifies the maximum amount of time a host can be
a member of a multicast group after sending a done timer
membership report. The default is 10 seconds.
state – Allows the user to enable or disable MLD snooping for the
specified VLAN.
Only administrator or operator-level users can issue this command.
DGS3100# config mld_snooping
Command: config mld_snooping
mrouter_port
Config Mld Snooping Router Port
mrouter_port_forbidden Config Mld Snooping Forbidden Router Port