Table of Contents
Advertisement
NTADDR
Ethernet IP Address
Type
Communication Interface
Syntax
NTADDR<i,i,i,i>
Units
i,i,i,i = IP address (commas are used in place of periods)
Range
i = 0-255
Default
192,168,10,30 (network address is 192.168.10.30)
Response
NTADDR:
*192,168,10,30
See Also
TNTMAC
Use the
command to change the Gem6K drive's IP address (e.g., to correct an IP address conflict).
NTADDR
NOTE: The Gem6K drive needs to be reset (cycle power or issue
address to take effect.
The
setting is automatically saved in battery backed RAM.
NTADDR
NTFEN
Ethernet Communication Enable
Type
Communication Interface
Syntax
NTFEN<b>
Units
b = Ethernet enable bit
Range
0 (disabled),
1 (enabled for Windows 95/98, no File Sharing, closed network),
2 (enabled – recommended for most Ethernet configurations)
Default
0 (Ethernet communication is disabled)
Response
NTFEN:
*0
See Also
NTADDR, NTMASK, TNT, TNTMAC
Use the
command to enable or disable Ethernet communication. The factory default configuration is
NTFEN
that Ethernet communication is disabled (
the Gem6K's "RS-232" serial port (COM2) and send the
Ethernet configuration (see options below). Then you can communicate over the Ethernet connection.
Options:
: Use
NTFEN0
NTFEN0
:
is primarily intended for use with Windows 95/98 with no File Sharing and a
NTFEN1
NTFEN1
closed network.
:
is recommended as the standard Ethernet communication mode, even if you are
NTFEN2
NTFEN2
using a closed network and no file sharing.
Windows NT, or Windows 95/98 with File Sharing and/or an open network.
NOTE: When using
(see Programmer's Guide).
NOTE: You can communicate to either the "
The
setting is automatically saved in battery backed RAM. Thus, if you cycle power, Ethernet
NTFEN
communication will still be enabled.
If the Ethernet connection fails, the Gem6K will set error status bit #22 (see
checking bit #22 is enabled with the
the
program.
ERRORP
). To enable Ethernet communication, you must connect to
NTFEN0
NTFEN
to disable Ethernet communication.
, you must also follow the ARP -S Static Mapping procedure
NTFEN2
" port or the "
ETHERNET
command. Also, if this error occurs, the Gem6K will branch to
ERROR
www.comoso.com
Product
GT6K
GV6K
command) in order for the new
RESET
Product
GT6K
GV6K
command which is appropriate for your
is especially useful if you are using
NTFEN2
" port at one time.
RS-232/485
,
, and
ER
TER
TERF
Command Descriptions
Rev
6.0
6.0
Rev
6.0
6.0
) if error-
207
Advertisement
Table of Contents
