Mounting The Process Unit - Canon iR C6800 Series Service Manual

10) Fix the joint plate [1] in place using 2 binding
screws [2].
[2]
F-2-65
11) Remove the paper put between the photosensitive
drum and the developing rotary.
12) Fit the protrusion [1] of the included black
assembly locking plate into the positioning hole [2]
found at the rear of the machine.
[2]
[1]
F-2-66
13) Fix the black developing assembly locking plate
[1] in place using the included screw (binding; M4x8)
[2].
[1]
[1]
F-2-67
14) Close the process unit.
Take care not to trap the cable found at the right front
of the machine by the process unit. Be sure to close the
process unit while the front cover is fully open.
If you cannot fit the process unit al the way to the rear,
go through the following:
Slide out the process unit, and turn the developing
rotary drive gear found on the host side slightly;
thereafter, be sure to close the process unit.
2.2.9 Mounting the Process
Unit
1) Match the area [1] where the resistance of the high
voltage cable is found in the upper left of the front
against the 4 pins [2] of the host machine; then, fix it
in place using the 4 clamps [3].
[3] [2]
[2]
F-2-68
Chapter 2
[2]
0002-6689
[3]
[1]
2-19