Canon iR C6800 Series Service Manual page 65

[1]
F-2-8
5) Move the machine in the direction of the arrow;
then, take out the 2 slope plates [2] from the middle of
the skid [1].
[2]
F-2-9
6) Detach the 2 pins taped to the back of the slope
plate.
7) Turn over the slope plate [1], and set it as shown;
then, match the skid and the slope plate by their pin
holes, and fit the pin [2] (1 pc. each).
[2]
[1]
F-2-10
[1]
Check to make sure that the caster [1] has not rolled
off the skid [2]. Also, be sure that it has not ridden
over the edge [3] of the skid.
[2] [1] [3]
F-2-11
8) While holding the grips on the delivery side of the
machine, move the machine along the slope plates and
off the skid.
9) Remove the packing tape from the machine.
10) Remove the 2 grips from the pickup side.
[1]
F-2-12
Chapter 2
[1]
2-7