After Replacing The Hdd - Canon iR C6800 Series Service Manual

Chapter 4
2) Remove the 6 screws [1], and detach the HD cover
[2].
[2]
[1]
F-4-101
3) Remove the 4 screws [1], and detach the HDD [2].
[1]
F-4-102
4.7.8.4 After Replacing the
HDD
A. If NetSpot Accountant (NSA) Is Not Used
1) Format the HDD.
Start up the machine in safe mode (i.e., turn on the
main power while holding down the 2 and 8 keys).
Using the SST's HD formatting function, execute
formatting of all partitions. (For details, see the
instructions on how to upgrade the machine.)
2) Download the system software.
Using the SST, download the system, language,
and RUI files.
It may take about 5 min for the machine to start up
4-44
[1]
[1]
[1]
[2]
0003-5556
after a download session.
B. If a Card Reader and NetSpot Accountant
(NSA) Are Used
A card ID used by the NSA exists on the HDD. If you
have replaced the HDD, you must also download
the card data used by the NSA once again;
otherwise, you will not be able to make use of
statistical management functions of the NSA.
You will first have to format the HDD and download
the system software as for A above; thereafter, you
need to perform additional steps:
1) Format the HDD.
2) Download the system software.
3) Make the following selections:
COPIER>FUNCTION>INSTALL>CARD
4) Enter a card number.
Enter the number of the first card of those to be used
for group control, and press the OK key. (For
instance, if the group will be using numbers
between 1 through 1000, enter '1'.)
5) Turn off and then on the machine's main power.
6) Make a check.
Make the following selections in Additional
Function: system control settings>group ID
control>count control; then, check to make sure the
following IDs are made ready: ID00000001
through ID00001000.
7) Set the appropriate addresses.
Make the following selections in Additional
Function: system
settings>TCP/IP settings>IP address. Then, set the
following addresses: IP address, gateway address,
subnet mask.
8) Enter a number.
Make the following selections in Additional
Function, and enter a number: system administrator
information settings>system control group ID/
system control ID No.
9) Turn off and then on the machine's main power.
Unless you set up the system control ID and the
control settings>network