Chapter 7
Memo :
E013 0001 (waste toner full error)
indicates that the soft counter reading is 250000 or higher.
E013 0002 (waste toner feedscrew error)
indicates that the output of the waste toner lock detecting switch (SW1) is "1" for 1 sec or more. (If the waste toner
feedscrew fails to rotate when the developing motor (M3) is driven, the waste toner feedscrew is pushed in the
direction of the arrow, thus turning on SW1.)
1. The reading of the waste toner may be checked or reset using the following service mode item:
COPIER>COUNTER>MISC>WASTE TNR
2. The timing of messages (waste toner full pre warning, waste toner full warning) may be changed using the
following serve mode item:
* to change the timing of indicating the waste toner full pre warning, COPIER>ADJUST>MISC>WT FL LM (at
time of shipment, set to 210000).
* to change the timing of indicating the waste toner full error, COPIER>ADJUST>MISC>WT ER LV (at time of
shipment, set to 40000).
7-70