Canon iR C6800 Series Service Manual page 73

6) Have the appropriate color developing assembly on
hand by checking the ID mark [1] attached to the
developing rotary assembly.
The following shows the ID mark attached to the cyan
color developing assembly.
[1]
F-2-47
7) Place A3 paper on a smooth table, and place the
appropriate color developing assembly.
8) With the developing cylinder of the color
developing assembly facing upward, detach he tape
[1]; then, pull out the protective sheet [2] while
holding both its edges.
[2]
[1]
F-2-48
1. Do not touch the developing cylinder.
2. After finishing the foregoing step, be sure to change
the orientation of the color developing assembly so
that the sponge side faces upward.
9) Remove the tape [1], and detach the sponge.
Toner and starter can start to leak when the sponge
has been detached. Do not keep the supply mouth
facing down during the work.
[1]
F-2-49
10) Check for scratches on the developing cylinder
while turning the developing cylinder gear [1] 5 to 6
times in the direction of the arrow. The work also
serves to even out the starter inside the unit.
F-2-50
11) Make sure that the color developing assembly
matches the ID mark; then, fit it in the developing
rotary.
To do so, start with the front of the color developing
assembly; while keeping its front fully against the
front of the developing assembly, fit its rear in place.
Try holding the color developing assembly by
both its ends to facilitate the work.
F-2-51
Chapter 2
[2]
[1]
2-15