Chapter 2
Be sure also that the rib [4] at the front of the
developing assembly matches the right guide at the
front of the machine.
[2]
[1]
[5]
[4]
F-2-60
When fitting the black developing assembly in the
machine, try keeping the high voltage cable [1] on top
of the assembly. Otherwise, the cable can get trapped
when the assembly is put inside the machine.
[1]
F-2-61
2-18
[3]
7) Route the cable [1] having the tube of the black
developing assembly through the hole [2] indicated in
the figure.
[1]
F-2-62
8) Route the high voltage cable [1] of the black
developing assembly along the side of the toner
supply mouth [2].
[2]
F-2-63
9) Connect the connector [1] found at the inside front.
F-2-64
[2]
[1]
[1]