Canon iR C6800 Series Service Manual page 71

16) Remove the 3 binding screws (M4x8) [1].
[1]
F-2-38
17) Shift down the fixing/feeding assembly releasing
lever [1] in the direction of the arrow.
F-2-39
18) Slide out the fixing/feeding assembly [1] to the
front.
[1]
F-2-40
19) Push the 2 slide out hook [1] found on both sides
of the fixing/feeding assembly, and fully slide out the
fixing/feeding assembly [2].
[1]
[1]
F-2-41
20) Lift both ends [1] of the process unit slightly; then,
fully slide out the process unit [2] to the front.
[2]
F-2-42
1. Be sure to take care not to deform the joint plate
found at the left end when drawing out the process
unit.
2. When drawing out the process unit, be careful not
to lift the process unit more than necessary. The unit
may slip off the rails, not permitting detachment.
3. When you have slid out the process unit, try placing
paper between the photosensitive drum and the
developing rotary to protect the drum from scratches
and light.
Chapter 2
[2]
[1]
[1]
2-13