Pluggables And Cabling Commands; Introduction - Allied Telesis x310-26FT Command Reference Manual

7

Introduction

Overview This chapter provides an alphabetical reference of commands used to configure
and monitor Pluggables and Cabling, including:
•
•
•
For more information, see the
Configuration_Guide.
Command List •
•
•
•
•
•
•
•
•
•
•
•
•
C613-50103-01 REV A
Pluggables and
Cabling Commands
Cable Fault Locator for finding faults in copper cabling
Optical Digital Diagnostic Monitoring (DDM) to help find fiber issues when
links go down
Active Fiber Monitoring for detecting changes in optical power received over
fiber cables.
"clear test cable-diagnostics
"debug fiber-monitoring" on page 283
"fiber-monitoring action" on page 285
"fiber-monitoring baseline" on page 286
"fiber-monitoring enable" on page 288
"fiber-monitoring interval" on page 289
"fiber-monitoring sensitivity" on page 290
"show system fiber-monitoring" on page 292
"show system pluggable" on page 295
"show system pluggable
"show system pluggable
"show test cable-diagnostics
"test cable-diagnostics tdr
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Pluggables and Cabling Feature Overview and
tdr" on page 282
detail" on page 297
diagnostics" on page 300
tdr" on page 302
interface" on page 303
281