Table of Contents
Advertisement
GUI C
OMMANDS
-
LOG EVENT
HOST
log event-host
Overview
Use this command to set up an external host to log AMF topology events through
Vista Manager. This command is run on the Master device.
Use the no variant of this command to disable log events through Vista Manager.
Syntax
log event-host [<ipv4-addr>|<ipv6-addr>] atmf-topology-event
no log event-host [<ipv4-addr>|<ipv6-addr>] atmf-topology-event
Parameter
<ipv4-addr>
<ipv6-addr>
Default
Log events are disabled by default.
Mode
Global Configuration
Usage
Event hosts are set so syslog sends the messages out as they come.
NOTE
•
•
Example
To enable Node 1 to log event messages from host ipv6 address 192.0.2.31, use the
following commands:
Node1#
Node1(config)#
To disable Node 1 to log event messages from host ipv6 address 192.0.2.31, use the
following commands:
Node1#
Node1(config)#
Related
atmf topology-gui enable
Commands
C613-50103-01 REV A
Description
ipv4 address of the event host
ipv6 address of the event host
: There is a difference between log event and log host messages:
Log event messages are sent out as they come by syslog
Log host messages are set to wait for a number of messages (20) to send
them out together for traffic optimization.
configure terminal
log event-host 192.0.2.31 atmf-topology-event
configure terminal
no log event-host 192.0.2.31 atmf-topology-event
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
206
Advertisement
Table of Contents
