Table of Contents
Advertisement
U
A
C
SER
CCESS
OMMANDS
SERVICE TELNET
service telnet
Overview
Use this command to enable the telnet server. The server is enabled by default.
Enabling the telnet server starts the device listening for incoming telnet sessions
on the configured port.
The server listens on port 23, unless you have changed the port by using the
privilege level
Use the no variant of this command to disable the telnet server. Disabling the
telnet server will stop the device listening for new incoming telnet sessions.
However, existing telnet sessions will still be active.
service telnet [ip|ipv6]
Syntax
no service telnet [ip|ipv6]
Default
The IPv4 and IPv6 telnet servers are enabled by default.
The configured telnet port is TCP port 23 by default.
Mode
Global Configuration
Examples
To enable both the IPv4 and IPv6 telnet servers, use the following commands:
awplus#
awplus(config)#
To enable the IPv6 telnet server only, use the following commands:
awplus#
awplus(config)#
To disable both the IPv4 and IPv6 telnet servers, use the following commands:
awplus#
awplus(config)#
To disable the IPv6 telnet server only, use the following commands:
awplus#
awplus(config)#
Related
clear line vty
Commands
show telnet
telnet server
C613-50103-01 REV A
command.
configure terminal
service telnet
configure terminal
service telnet ipv6
configure terminal
no service telnet
configure terminal
no service telnet ipv6
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
178
Advertisement
Table of Contents
