Remove And Replace Frus; Rrp 1: Sfp Optical Transceiver; Tools Required; Concurrent Frus - HP 316095-B21 - StorageWorks Edge Switch 2/24 Service Manual

Remove and Replace FRUs

This section describes procedures to remove and replace concurrent switch FRUs,
along with tools required to perform each procedure. Concurrent FRUs are
removed and replaced while the switch is powered on and operational.
Table 21
powered on and operational. The table also lists ESD precautions (yes or no) for
each FRU, and references the page number of the removal and replacement
procedure.
Table 21: Concurrent FRUs
Small form factor pluggable (SFP) optical
transceiver
Redundant power supply (with internal
cooling fans)

RRP 1: SFP Optical Transceiver

Use the following procedures to remove or replace an SFP optical transceiver
from the front of the switch chassis. A list of tools required is provided.

Tools Required

The following tools are required to perform these procedures.
Edge Switch 2/24 Service Manual
lists concurrent FRUs that are removed and replaced while the switch is
Concurrent FRU Name
Protective cap (provided with the fiber-optic jumper cable).
Loopback plug (provided with the switch).
Fiber-optic cleaning kit.
FRU Removal and Replacement
ESD Precaution
Requirement
No page 175
No page 179
Page
175