Table of Contents
Advertisement
12.1 Display Settings
12.1.1 Display setting functions
Setting regarding display is possible. The items which can be set are shown below.
Items
Screen save time
Screen save backlight
Brightness
Contrast
Opening time
12 - 2
12.1 Display Settings
12.1.1 Display setting functions
GT1020
GT1030
The period from the user stops the touch panel operation till the screen save
function starts can be set.
Whether turn ON or OFF the backlight simultaneously at the screen save
function start can be specified.
The brightness
-
can be adjusted.
Contrast can be adjusted.
The title display period at the main unit boot can be set.
(1) Display setting by drawing software
Set title display period, opening time, screen save time and screen save backlight
at [GOT set up] in [System Environment] of GT Designer2.
When using GT Designer3, execute the settings at [GOT Setup...] in [[GOT
Environmental Setting] of [Common].
When change a part of the setting after downloading the project data, change the
setting by [Display] screen of the GOT.
GT Designer2 Version
GT Designer3 Version
(2) Screen save and screen save backlight OFF function
When using the screen save and screen save back light OFF function, select
valid/invalid by the system information reading device in [System Environment] of
GT Designer2.
When using GT Designer3, select valid/invalid by the reading device of [System
Information...] in [GOT Environmental Setting].
For system information details, refer the following.
GT Designer2 Version
GT Designer3 Version
Contents
GT104
GT105
-
Screen Design Manual
Screen Design Manual (Fundamentals)
Screen Design Manual
Screen Design Manual (Fundamentals)
Setting range
0 to 60 minutes
<At factory shipment: 0 minutes>
When set to 0, the function
becomes invalid.
ON/OFF
<At factory shipment: OFF>
-
8-level adjustment (0 to 7)
16-level adjustment (0 to 15)
<At factory shipment: 10>
0 to 60 seconds
<At factory shipment: 5 seconds >
Advertisement
Table of Contents
