Creating A Vlan And Enabling Igmp Snooping; Adding An Interface To A Vlan - Huawei Quidway S2700 Series Configuration Manual

Quidway S2700 Series Ethernet Switches
Configuration Guide - Multicast
Pre-configuration Tasks
Before configuring static Layer 2 multicast in a VLAN, complete the following tasks:
l
l
Data Preparation
To configure static Layer 2 multicast, you need the following data.
No.
1
2
3

1.4.2 Creating a VLAN and Enabling IGMP Snooping

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
vlan vlan-id
A VLAN is created and the VLAN view is displayed.
Step 3 Run:
igmp-snooping enable
The IGMP snooping is enabled in the VLAN.
----End

1.4.3 Adding an Interface to a VLAN

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
Issue 01 (2011-07-15)
Connecting interfaces and configuring the physical parameters of each interface to make
the physical layer in Up state
Enabling IGMP snooping globally
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 IGMP Snooping Configuration
Data
Type and number of the interface that needs
to join a multicast group statically
ID of the VLAN that the interface belongs to
IP address of the multicast group
16