Honda CB900F Service Manual page 62

MAINTENANCE
ENG INE OIL/OIL FILTER
Oil lEVEL INSPECTION
Start the engine and let it idle for 2 - 3 minutes.
Turn off the engine and support the motorcycle level
surface.
Check the oil level through the inspection window.
OIL DRAIN BOLT/SEALING WASHER
Other viscosities
sho wn in the
chart may be
used when the
average tempera-
ture in your riding
area
is
within the
indicated range,
Change the
eng ine oil with
the engine warm
and the motorcy-
cle on level
ground to assure
complete
draining.
If the level is below the lower line, remove the oil filler
cap and fill the crankcase with recommended oil up to
the upper level line .
Remove the oil filler cap.
Fill the recommended engine oil up to the upper level
line.
RECOMMENDED ENGINE OIL:
Pro Honda GN4 or HP4 (without molybdenum
additives) 4-stroke oil (USA & Canadal. or Honda
a-stroke oil (Canada only). or an equivalent motor
oil API service classification 5G or Higher except
oils labeled as energy conserving on the API
service label.
JASO T903 standard MA
Viscosity: SAE 10W-40
Reinstall the filler cap.
ENGINE Oil
&
FilTER CHANGE
Warm up the engine.
Stop the engine and remove the oil filler cap.
Remove the drain bolt, drain the oil completely.
Check that the sealing washer on the drain bolt is in
o
-10
o
10
20
30 40°C
good condition, and replace if necessary.
Install and tighten the drain bolt.
TORQUE : 29 Nom (3.0 kg/om, 22 IbMt)
Remove and discard the oil filter cartridge using the
special tool.
3-'\2
TOOL:
Oil filter wrench 07HAA-PJ70100