Honda CB900F Service Manual page 351

Place the master cylinder assembly on the handlebar.
Align the end of the master cylinder with the punch
mark on the handlebar.
Install the master cylinder holder with the "UP" mark
facing up.
Tighten the upper bolt first, then the lower bolt to the
specified torque .
TORQUE : 12 N·m (1.2 kqf-m, 9 Ibfoft )
Install the brake hose eyelet with the oil bolt and new
sealing washers .
Push the eyelet joint against the stopper, then tighten
the oil bolt to the specified torque.
TORQUE : 34 N·m (3.5 kqf-m, 25 Ibfoft)
Connect the brake light switch wire connectors.
Fill the reservoir to the upper level and bleed the
brake system (page 15-4).
REAR MASTER CYLINDER
MASTER CYLIND ER
RESERVOIR
HYDRAULIC BRAKE
HOLDER
SEALING
WASH ERS
SWITCH CONNECTOR
Avoid spilling fluid
on painted, plas-
tic. or rubbe r
parts . Place
a
rag
over these parts
w henever the
s ystem is
serv iced.
REMOVAL
Drain the rear hydraulic system (page 15-41.
Disconnect the brake light switch 2P connector.
Remove the rear master cylinder reservoir mounting
bolt/nut.
Remove the brake hose oil bolt, sealing washers and
brake hose.
Loosen the rear master cylinder mounting bolts.
Remove the socket bolts and footpeg bracket
assembly.
15-15