Honda CB900F Service Manual page 163

FUEL SYSTEM (Programmed Fuel Injection)
NORMAL
POSITION
Place the bank angle sensor horizontal as shown, a nd
turn the ignition switch ON.
The bank angle sensor is norma l
if
the engine stop
relay clicks and pow er supply is closed .
Incline the bank angle sensor app roximately 60
degrees to the left or right with the ignition switch
ON.
The bank angle sensor is normal
if
the engine stop
relay clicks and power supply is open .
If you repeat this test, first turn the ignition sw itch
OFF, then turn the ignition switch ON .
REMOVAL/INSTALLATION
Disconnect the bank angle sensor 3P (Green) connec-
tor.
Remove the two screws , nuts and bank angle sensor.
Install the bank
angle sensor with
Installation is in the reverse order of removal.
its "UP" mark
facing up.
lighten the mounting screws securely.
ENGINE STOP RELAY
INSPECTION
Check the w ire
color when you
Disconnect the engine stop relay 4P connector.
select the engine
stop relay.
60' BANK A NGLE POSITION
~
"<:"
60' .
(ap p ro x im ate ly)
©1.
60'
(ap p ro xi m at ely)
BANK A NGLE SENSOR
ENGINE STOP RELAY
5-75