Honda CB900F Service Manual page 137

FUEL SYSTEM (Programmed Fuel Injection)
Connect t he ohm m et er t o t he f uel cu t relay connector
t erm inals.
CONNECTION: Blac k/White - Brown
Con nect the 12V battery to the following fuel cut relay
connector terminals.
CONNECTION : Brown/Black - Black/White
There should be continuity only when the 12V battery
is connected .
If there is no continuity when t he 12V battery is con -
nected, replace th e fuel cut relay .
FUEL CUT RELAY
\
,
BATTERY
FUEL TANK
REMOVAL
Remove the side cover (page 2-2 ).
Loosen the fuel tank mounting bolt/nut.
Do not remove
the maintenance
wire bolt yet.
Slide the fuel tank t o t he backward.
Open the f ront end of the fuel tank and support it
using a suitable support .
Tighten the fuel tank mounting bolt/nut to t he speci -
fie d torqu e.
TORQUE: 12 N·m (1.2 kqf-rn, 9 Ibf·ftl
Releas e th e fu el pressure (page 5-44) .
Disconnect the fuel tank air vent hose and overflow
tube.
Remove t he fuel hose sealing nut and sealing wash -
ers, then disconnect the fuel hose (page 5-4 4).
NOTE:
Do not apply excessive force to the fue l pipe.
• Always hold the fuel pipe nut while removing the
fuel hose sealing nut.
Temporarily install the 12 X 30 mm bolt (pitch 1.251
and sealing washers to the fuel hose banjo, then tight-
en the sealing nut.
FUEL TANK
5-49