Mld-Snooping Router-Aging-Time - H3C S3100 Series Command Manual

Description
Use the mld-snooping report source-ip command to configure the source IPv6 address of the MLD
reports sent by the MLD Snooping proxy.
Use the undo mld-snooping report source-ip command to restore the default.
By default, the source IPv6 address of the MLD reports sent by the MLD Snooping proxy is
FE80::02FF:FFFF:FE00:0001.
Note that:
Before configuring this command in a VLAN, enable MLD Snooping in the VLAN.
The source IPv6 address configured in the mld-snooping report source-ip command also
applies when the simulated host sends MLD reports.
Related commands: mld-snooping enable.
Examples
# Enable MLD Snooping in VLAN 2 and configure the source IPv6 address of MLD reports sent by the
MLD Snooping proxy in VLAN 2 to FE80:0:0:1::1.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping report source-ip fe80:0:0:1::1

mld-snooping router-aging-time

Syntax
mld-snooping router-aging-time interval
undo mld-snooping router-aging-time
View
VLAN view
Default Level
2: System level
Parameters
interval: Dynamic router port aging time, in seconds. The effective range is 1 to 1,000.
Description
Use the mld-snooping router-aging-time command to configure the aging time of dynamic router
ports in the current VLAN.
Use the undo mld-snooping router-aging-time command to restore the default setting.
By default, the dynamic router port aging time is 260 seconds.
This command takes effect only if MLD snooping is enabled in the VLAN.
Related commands: mld-snooping enable, router-aging-time.
2-19