Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\QoS.fm
service-policy
Use the service-policy Interface Configuration (Ethernet, VLAN, Port-
channel) mode command to apply a policy map to the input of a particular
interface. Use the no form of this command to detach a policy map from an
interface.
Syntax
policy-map-name
service-policy input
no service-policy input
Parameters
policy-map-name—Specifies the policy map name to apply to the input
interface. (Length: 1–32 characters)
Command Mode
Interface Configuration (Ethernet, VLAN, Port-channel) mode
User Guidelines
Only one policy map per interface per direction is supported.
Example
The following example attaches a policy map called Policy1 to the input
interface.
Console(config-if)#
policy1
service-policy input
qos aggregate-policer
Use the qos aggregate-policer Global Configuration mode command to
define the policer parameters that can be applied to multiple traffic classes.
Use the no form of this command to remove an existing aggregate policer.
Syntax
aggregate-policer-name committed-rate-kbps excess-
qos aggregate-policer
burst-byte
exceed-action {drop | policed-dscp-transmit}]
[
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
735
Quality of Service (QoS) Commands
Advertisement
Table of Contents
