Dell PowerConnect PC5524 Reference Manual page 129

FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
• interface-name—Specifies the outgoing interface name. The interface
name has the format:
physical-port-name
{
digit integer
} | {
If the egress interface is not specified, the default interface is selected.
Specifying interface zone=0 is equal to not defining an egress interface.
Understanding Invalid Combinations of Source and Destination
Some invalid combinations of source and destination exist. Specifically, if one
of the following conditions exists:
• The source file and destination file are the same file.
• xmodem: is the destination file. The source file can be copied to image,
boot and null: only.
• tftp:// is the source file and destination file on the same copy.
• *.prv files cannot be copied.
• The source or destination is a slave unit (except for image and boot files).
 mirror-config cannot be used as a destination
The following table describes the copy characters:
C h a r a c t e r D e s c r i p t io n
! For network transfers, indicates that the copy process is taking place.
Each exclamation point indicates successful transfer of ten packets (512
bytes each).
. For network transfers, indicates that the copy process timed out.
Generally, several periods in a row means that the copy process may fail.s
Copying an Image File from a Server to Flash Memory
source-url
Use the copy
to flash memory.
Copying a Boot File from a Server to Flash Memory
source-url
Use the copy
flash memory.
Copying a Configuration File from a Server to the Running Configuration
File
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
CLI\files\Configuration_Image.fm
vlan integer
{ } |
}.The subparameter
decimal-digit decimal-digit
}{ }.
image command to copy an image file from a server
boot command to copy a boot file from a server to
Configuration/Image File Commands
ch integer isatap{integer
{ } |
integer
has the format: {
has the range 0–9
} |
decimal-
129