Sflow Commands; Sflow Receiver - Dell PowerConnect PC5524 Reference Manual

Table of Contents

FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax

sFlow Commands

Use the sflow receiver Global Configuration mode command to define sFlow

collector. Use the no form of this command to remove the definition of the

index {ipv4-address | ipv6-address | hostname} [port port]

sflow receiver

[max-datagram-size bytes]

no sflow receiver

index—The index of the receiver. (Range: 1–8)

ipv4-address—Pv4 address of the host to be used as an sFlow Collector.

ipv6-address—IPv6 address of the host to be used as an sFlow Collector.

When the IPv6 address is a Link Local address (IPv6Z address), the

outgoing interface name must be specified. Refer to the User Guidelines

for the interface name syntax.

hostname—Hostname of the host to be used as an sFlow Collector. Only

translation to IPv4 addresses is supported.

port—Port number for syslog messages. If unspecified, the port number

defaults to 6343. The range is 1-65535.

bytes—Specifies the maximum number of bytes that can be sent in a

single sample datagram. If unspecified, it defaults to 1400.

No receiver is defined.

D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY

CLI\files\750_sFlow.fm

sFlow Commands