Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\PoE.fm
Undefined error during Force On
Supply voltage higher than settings
Supply voltage lower than settings
Disable_PDU flag raised during Force On
Port is forced on, then disabled
Port is off – forced power error due to Overload
Port is off - "out of power budget" during Force On
Communication error with PoE devices after Force On
Port is off – short condition
Port is off – over temperature at the port
Port is off – device is too hot
Unknown device port status
Force Power Error Short Circuit
Force Power Error Channel Over Temperature
Force Power Error Chip Over Temperature
Power Management-Static
Power Management-Static -ovl
Force Power Error Management Static
Force Power Error Management Static -ovl
High power port is ON
Chip Over Power
Force Power Error Chip Over Power
show power inline consumption
Use the show power inline consumption EXEC mode command to display
information about the inline power consumption for all interfaces or for a
specific interface.
Syntax
[interface-id | module stack-member-
show power inline consumption
number]
Parameters
Interface-id—Specifies an interface ID. The interface ID must be an
Ethernet port.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
365
Power over Ethernet (PoE) Commands
Advertisement
Table of Contents
