Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
no autobaud
Default Configuration
Automatic baud rate detection is disabled.
Command Mode
Line Configuration mode
User Guidelines
To start communication using Autobaud, press the Enter key twice.
Example
The following example enables autobaud.
Console(config)#
Console(config-line)#
exec-timeout
The exec-timeout Line Configuration mode command sets the session idle
time interval, during which the system waits for user input before automatic
logoff. Use the no form of this command to restore the default configuration.
Syntax
minutes
exec-timeout
no exec-timeout
Parameters
•
minutes—Specifies the number of minutes. (Range: 0-65535)
•
seconds—Specifies the number of seconds. (Range: 0-59)
Default Configuration
The default idle time interval is 10 minutes.
Command Mode
Line Configuration mode
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
CLI\files\Line.fm
line console
autobaud
seconds
[
]
Line Commands
215
Advertisement
Table of Contents
