Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
Static multicast addresses can be defined on static VLANs only.
You can execute the command before the VLAN is created.
Example
The following example registers the MAC address to the bridge table:
Console(config)#
Console(config-if)#
The following example registers the MAC address and adds ports statically.
Console(config)#
Console(config-if)#
gi1/0/1-2
add
bridge multicast forbidden address
Use the bridge multicast forbidden address Interface Configuration (VLAN)
mode command to forbid adding or removing a specific multicast address to
or from specific ports. Use the no form of this command to restore the default
configuration.
Syntax
bridge multicast forbidden address {
{ethernet interface-list | port-channel port-channel-list
no bridge multicast forbidden address {
Parameters
•
mac-multicast-address—Specifies the group MAC multicast address.
•
add—Forbids adding ports to the group.
•
remove—Forbids removing ports from the group.
ethernet interface-list—Specifies a list of Ethernet ports. Separate
•
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
CLI\files\Address_Table.fm
interface vlan
bridge multicast address
interface vlan
bridge multicast address
mac-multicast-address
8
01:00:5e:02:02:03
8
01:00:5e:02:02:03
}
mac-multicast-address
Address Table Commands
{add | remove}
}
}
389
Advertisement
Table of Contents
