Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
off—Disables Flow Control.
•
Default Configuration
Flow control is enabled.
Command Mode
Interface Configuration (Ethernet, Port-channel) mode
User Guidelines
Use the negotiation command to enable flow control auto.
Example
The following example enables Flow Control on port
Console(config)#
Console(config-if)#
flowcontrol (Global)
Use the flowcontrol Global Configuration mode command to configure the Flow
Control global mode.
Syntax
receive-only
flowcontrol {
Parameters
•
receive-only—The interfaces with enabled Flow Control will receive pause
frames, but will not send Flow Control pause frames.
•
send-receive—The interfaces with enabled Flow Control will receive and
send pause frames.
Default Configuration
receive-only.
Command Mode
Global Configuration mode
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
334
Ethernet Configuration Commands
CLI\files\Ethernet.fm
gigabitethernet 1/0/1
interface
flowcontrol on
send-receive
|
}
1
gi1/0/
Advertisement
Table of Contents
