Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
show storm-control
Use the show storm-control EXEC mode command to display the
configuration of storm control.
Syntax
show storm-control
Parameters
interface-id—Specifies the interface.
Command Mode
EXEC mode
Example
console# show storm-control
Port
State
------ -------- --------------- ------------------------
gi1/0/
1 Enabled
gi1/0/
2 Disabled 100000
User Guidelines
Use the storm-control broadcast enable Interface Configuration command to
enable storm control.
The calculated rate includes the 20 bytes of Ethernet framing overhead
(preamble+SFD+IPG).
If the suppression level in percentage is translated (for the current port's
speed) to a rate that is lower then the minimum rate, the minimum rate
would be set.
Example
console(config)# interface gi1/0/1
console(config-if)# storm-control broadcast level kbps 12345
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
350
Ethernet Configuration Commands
CLI\files\Ethernet.fm
[interface-id ]
Rate [Kbits/Sec] Included
12345
Broadcast, Multicast,
Unknown unicast
Broadcast
Advertisement
Table of Contents
