Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
Syntax
{any | source source-wildcard} {any | destination destination-wildcard} [eth-type
permit
0| aarp | amber | dec-spanning | decnet-iv | diagnostic | dsm | etype-6000] [vlan vlan-id]
[cos cos cos-wildcard] [time-range time-range-name]
Parameters
source—Source MAC address of the packet.
•
source-wildcard—Wildcard bits to be applied to the source MAC
•
address. Use 1s in the bit position that you want to be ignored.
destination—Destination MAC address of the packet.
•
destination-wildcard—Wildcard bits to be applied to the destination
•
MAC address. Use 1s in the bit position that you want to be ignored.
eth-type—The Ethernet type in hexadecimal format of the packet.
•
vlan-id—The VLAN ID of the packet. (Range: 1–4094)
•
cos—The Class of Service of the packet. (Range: 0–7)
•
cos-wildcard—Wildcard bits to be applied to the CoS.
•
time-range-name—Name of the time range that applies to this permit
•
statement. (Range: 1–32)
Default
No MAC access list is defined.
Command Mode
MAC Access-list Configuration mode
User Guidelines
You enter MAC-access list configuration mode by using the MAC Access-list
Global Configuration command.
After an access control entry (ACE) is added to an access control list, an
implied deny-any-any condition exists at the end of the list. That is, if there
are no matches, the packets are denied. However, before the first ACE is
added, the list permits all packets.
Example
console(config)# mac access-list extended server1
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 2 0 1 2 - F O R P R O O F O N LY
CLI\files\ACL.fm
709
Advertisement
Table of Contents
