Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
Using the no IPv6 address command without arguments removes all manually
configured IPv6 addresses from an interface, including link local manually
configured addresses.
Example
console(config)# interface vlan 1
console(config-if)# ipv6 address 3000::123/64 eui-64 anycast
ipv6 address link-local
Use the ipv6 address link-local command to configure an IPv6 link-local
address for an interface. Use the no form of this command to return to the
default link local address on the interface.
Syntax
ipv6-address/prefix-length
ipv6 address
no ipv6 address [i
Parameters
•
ipv6-address—Specifies the IPv6 network assigned to the interface.This
argument must be in the form documented in RFC 2373 where the
address is specified in hexadecimals using 16-bit values between colons.
•
prefix-length—Specifies the length of the IPv6 prefix. A decimal value
indicates how many of the high-order contiguous bits of the address
comprise the prefix (the network portion of the address). A slash mark (/)
must precede the decimal. Only 64-bit length is supported, according to
IPv6 over Ethernet's well-known practice
Default Configuration
IPv6 is enabled on the interface, link local address of the interface is
FE80::EUI64 (interface MAC address).
Command Mode
Interface Configuration (Ethernet, VLAN, Port-channel) mode. It cannot be
configured for a range of interfaces (range context).
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
628
IPv6 Addressing Commands
CLI\files\IPv6_Addressing.fm
pv6-address/prefix-length
link-local
link-local]
Advertisement
Table of Contents
