Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
bridge multicast address
Use the bridge multicast address Interface Configuration (VLAN) mode
command to register a MAC-layer multicast address in the bridge table and
statically add or remove ports to or from the group. Use the no form of this
command to unregister the MAC address.
Syntax
bridge multicast address {
interface-list
|
port-channel-list
port-channel
no bridge multicast address {
Parameters
•
mac-multicast-address—Specifies the group MAC multicast address.
•
add—Adds ports to the group.
•
remove—Removes ports from the group.
•
ethernet interface-list—Specifies a list of Ethernet ports. Separate
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
port-channel port-channel-list—Specifies a list of port channels. Separate
•
nonconsecutive port-channels with a comma and no spaces; use a hyphen
to designate a range of port channels.
Default Configuration
No multicast addresses are defined.
If ethernet interface-list or port-channel port-channel-list is specified
without specifying add or remove, the default option is add.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
To register the group in the bridge database without adding or removing ports
or port channels, specify the mac-multicast-address parameter only.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
388
Address Table Commands
CLI\files\Address_Table.fm
mac-multicast-address} [[add | remove] {ethernet
}]
mac-multicast-address
}
Advertisement
Table of Contents
