Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
Syntax
ipv6_addr interface-id hw_addr
ipv6 neighbor
no ipv6 neighbor
Parameters
•
Ipv6_addr—Specifies the Pv6 address to map to the specified MAC
address.
•
interface-id—Specifies the interface that is associated with the IPv6
address
•
hw_addr—Specifies the MAC address to map to the specified IPv6
address.
Command Mode
Global Configuration mode
User Guidelines
The IPv6 neighbor command is similar to the ARP (global) command.
If an entry for the specified IPv6 address already exists in the neighbor
discovery cache—learned through the IPv6 neighbor discovery process—the
entry is automatically converted to a static entry.
A new static neighbor entry with a global address can be configured only if a
manually configured subnet already exists in the device.
Use the show IPv6 neighbors command to view static entries in the IPv6
neighbor discovery cache.
Example
console(config)# ipv6 neighbor 3000::a31b vlan 1 001b.3f9c.84ea
ipv6 set mtu
Use the ipv6 mtu Interface Configuration mode command to set the
maximum transmission unit (MTU) size of IPv6 packets sent on an interface.
Use the default parameter to restore the default MTU size.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
CLI\files\IPv6_Addressing.fm
ipv6_addr interface-id
IPv6 Addressing Commands
637
Advertisement
Table of Contents
