Dell PowerConnect PC5524 Reference Manual page 706

FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
udp {any | {source-prefix/length }} {any | source-port/port-range}
deny
}{any | destination- prefix/length } {any| destination-port/port-range} [dscp
number | precedence number] [time-range time-range-name] [disable-port |
log-input]
Parameters
protocol—The name or the number of an IP protocol. Available protocol
•
names are: icmp (58), tcp (6) and udp (17). To match any protocol use
the ipv6 keyword. (Range: 0–255)
source-prefix/length—The source IPv6 network or class of networks
•
about which to set permit conditions. This argument must be in the form
documented in RFC 3513 where the address is specified in hexadecimal
using 16-bit values between colons.
destination-prefix/length—The destination IPv6 network or class of
•
networks about which to set permit conditions. This argument must be
in the form documented in RFC 3513 where the address is specified in
hexadecimal using 16-bit values between colons.
dscp number—Specifies the DSCP value. (Range: 0–63)
•
precedence number—Specifies the IP precedence value.
•
icmp-type—Specifies an ICMP message type for filtering ICMP packets.
•
Enter a number or one of the following values: destination-unreachable
(1), packet-too-big (2), time-exceeded (3), parameter-problem (4), echo-
request (128), echo-reply (129), mld-query (130), mld-report (131),
mldv2-report (143), mld-done (132), router-solicitation (133), router-
advertisement (134), nd-ns (135), nd-na (136). (Range: 0–255)
icmp-code—Specifies an ICMP message code for filtering ICMP
•
packets. (Range: 0–255)
destination-port—Specifies the UDP/TCP destination port. You can
•
enter a range of ports by using a hyphen. E.g. 20 - 21. For TCP enter a
number or one of the following values: bgp (179), chargen (19), daytime
(13), discard (9), domain (53), drip (3949), echo (7), finger (79), ftp
(21), ftp-data 20), gopher (70), hostname (42), irc (194), klogin (543),
kshell (544), lpd (515), nntp (119), pop2 (109), pop3 (110), smtp (25),
sunrpc (1110, syslog (514), tacacs-ds (49), talk (517), telnet (23), time
(37), uucp (117), whois (43), www (80). For UDP enter a number or one
of the following values: biff (512), bootpc (68), bootps (67), discard (9),
dnsix (90), domain (53), echo (7 ), mobile-ip (434), nameserver (42),
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 2 0 1 2 - F O R P R O O F O N LY
706
CLI\files\ACL.fm