Deny (Management) - Dell PowerConnect PC5524 Reference Manual

FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
Parameters
• interface-id:—Specify an interface ID. The interface ID can be one of the
following types: Ethernet port, Port-channel or VLAN
service
• service
SSH, HTTP, HTTPS and SNMP.
ipv4-address
•
ipv6-address/ipv6-prefix-length
•
source IPv6 address prefix length. The prefix length must be preceded by a
forward slash (/). The parameter is optional.
mask
• mask
parameter is relevant only to IPv4 addresses.
prefix-length
mask
•
source IPv4 address prefix. The prefix length must be preceded by a
forward slash (/). This parameter is relevant only to IPv4 addresses. (Range:
0–32)
Command Mode
Management Access-List Configuration mode
User Guidelines
Rules with ethernet, VLAN, and port-channel parameters are valid only if an
IP address is defined on the appropriate interface.
Example
The following example permits all ports in the access list called mlist
Console(config)#
Console(config-macl)#

deny (Management)

The deny Management Access-List Configuration mode command sets
conditions for the management access list.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
CLI\files\Management_ACL.fm
— Specifies the service type. Possible values are: Telnet,
— Specifies the source IPv4 address.
— Specifies the source IPv4 address network mask. This
— Specifies the number of bits that comprise the
management access-list
permit
— Specifies the source IPv6 address and
mlist
Management ACL Commands
153