Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\PoE.fm
power inline limit
Use the power inline limit Interface Configuration mode command to
configure the power limit per port on an interface. Use the no form of the
command to return to default.
Syntax
power
power inline limit
no power inline limit
Parameters
power—States the port power consumption limit in Milliwatts (Range: 0-
15400
Default Configuration
The default value is the maximum power allowed in the specific working
mode:
•
15.4W
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example sets inline power on a port.
console(config)# interface gi1/0/1
console(config-if)# power inline limit 2222
show power inline
Use the show power inline EXEC mode command to display information
about the inline power for all interfaces or for a specific interface.
Syntax
interface-id
module stack-member-number
show power inline [
|
]
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
361
Power over Ethernet (PoE) Commands
Advertisement
Table of Contents
