Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Spanning-Tree.fm
When root guard is enabled, the port changes to the alternate state if the
spanning-tree calculations select the port as the root port.
Example
The following example prevents gigabitethernet port 1/0/1 from being the
root port of the device..
Console(config)#
gigabitethernet 1/0/1
interface
Console(config-if)#
spanning-tree guard root
spanning-tree bpduguard
Use the spanning-tree bpduguard Interface Configuration (Ethernet, port-
channel) mode command to shut down an interface when it receives a bridge
protocol data unit (BPDU). Use the no form of this command to restore the
default configuration.
Syntax
{enable | disable}
spanning-tree bpduguard
no spanning-tree bpduguard
Parameters
enable—Enables BPDU Guard.
disable—Disables BPDU Guard.
Default Configuration
BPDU Guard is disabled.
Command Mode
Interface Configuration (Ethernet, Port-channel) mode
User Guidelines
The command can be enabled when the spanning tree is enabled (useful
when the port is in the PortFast mode) or disabled.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
466
Spanning-Tree Commands
Advertisement
Table of Contents
