Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
The following example displays information about the inline power for a
specific port.
console(config)# show power inline gi1/1/1
Port
Powered Device
-----
--------------
gi1/1/1 IP Phone Model A
Power limit (for port power-limit mode): 15.4W
Overload Counter: 0
Short Counter: 0
Denied Counter: 0
Absent Counter: 0
Invalid Signature Counter: 0
The following table describes the fields shown in the display:
F i e ld
Power
Nominal Power
Consumed Power
Usage Threshold
Traps
Port
Powered device
Admin State
Priority
Oper State
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
CLI\files\PoE.fm
State
Status
-------
------
Auto
On
D e s cr ip t i o n
The inline power sourcing equipment operational status.
The inline power sourcing equipment nominal power in
Watts.
The measured usage power in Watts.
The usage threshold expressed in percent for comparing
the measured power and initiating an alarm if threshold is
exceeded.
Indicates if inline power traps are enabled.
The Ethernet port number.
A description of the powered device type.
Indicates if the port is enabled to provide power. The
possible values are Auto or Never.
The port inline power management priority. The possible
values are Critical, High or Low.
Describes the port inline power operational state. The
possible values are On, Off, Test-Fail, Testing, Searching or
Fault.
Power over Ethernet (PoE) Commands
Priority
Class
--------
-------
High
Class0
363
Advertisement
Table of Contents
