FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Ethernet.fm
back-pressure
Use the back-pressure Interface Configuration (Ethernet) mode command to
enable back pressure on a specific interface. Use the no form of this
command to disable back pressure.
Syntax
back-pressure
no back-pressure
Default Configuration
Back pressure is enabled.
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example enables back pressure on port gi1/0/ 5.
Console(config)#
gigabitethernet 1/0/5
interface
Console(config-if)#
back-pressure
port jumbo-frame
Use the port jumbo-frame Global Configuration mode command to enable
jumbo frames on the device. Use the no form of this command to disable
jumbo frames.
Syntax
port jumbo-frame
no port jumbo-frame
Default Configuration
Jumbo frames are disabled on the device.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
337
Ethernet Configuration Commands