Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
Command Mode
Interface Configuration (Ethernet, port-channel) mode
switchport mode
Use the switchport mode Interface Configuration (Ethernet, port-channel)
mode command to configure the VLAN membership mode of a port. Use the
no form of this command to restore the default configuration.
Syntax
switchport mode
host} | customer }
no switchport mode
Parameters
•
access—Specifies an untagged layer 2 VLAN port.
trunk—Specifies a trunking layer 2 VLAN port.
•
general—Specifies a full 802-1q supported VLAN port.
•
•
customer—Specifies that the port is connected to customer equipment.
Used when the switch is in a provider network.
•
private-vlan promiscous—Private-VLAN promiscous port.
•
private-vlan host—Private-VLAN host port.
Default Configuration
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
•
When the port mode is changed, it receives the configuration
corresponding to the mode.
•
If the port mode is changed to access and the access VLAN does not exist,
then the port will not belongs to any VLAN.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
500
VLAN Commands
CLI\files\VLAN_ISCLI_Only.fm
{ access | trunk | general | private-vlan {promiscuous |
Advertisement
Table of Contents
