Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\LLDP.fm
Syntax
lldp transmit
no lldp transmit
Parameters
This command has no arguments or keywords.
Default
Enabled
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
LLDP manages LAG ports individually. LLDP sends separate advertisements
on each port in a LAG.
LLDP operation on a port is not dependent on the STP state of a port. I.e.
LLDP frames are sent on blocked ports.
If a port is controlled by 802.1X, LLDP would operate only if the port is
authorized.
Example
console(config)# interface gigabitethernet 1/0/1
console(config-if)# lldp transmit
lldp receive
Use the lldp receive Interface Configuration mode command to enable
receiving Link Layer Discovery Protocol (LLDP) on an interface. Use the no
form of this command to stop receiving LLDP on an interface.
Syntax
lldp receive
no lldp receive
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
424
LLDP Commands
Advertisement
Table of Contents
