Ipv6 Show Commands - Dell Networking N4000 Series Configuration Manual

IPv6 Show Commands

Use the following commands in Privileged EXEC mode to view IPv6
configuration status and related data.
Command
show sdm prefer
show sdm prefer dual-
ipv4-and-ipv6 default
show ipv6 dhcp interface
vlan-id
vlan
show ipv6 interface {vlan
| tunnel | loopback}
interface-id
show ipv6 brief
show ipv6 route [
address ipv6-
|
prefix/prefix-length
protocol interface-type
|
interface-number
show ipv6 route summary View summary information about the IPv6 routing table.
show ipv6 route
preferences
1262
Configuring IPv6 Routing
Purpose
Show the currently active SDM template.
Show parameters for the SDM template.
View information about the DHCPv6 lease acquired by
the specified interface.
View the IP interface configuration information for the
specified IPv6 routing interface.
View the global IPv6 settings for the switch.
ipv6-
View the routing table.
ipv6-address
•
|
best-matching route would be displayed.
protocol
•
] [best]
routes. Is one of the following keywords: connected,
ospf, static.
ipv6-prefix/ prefix-length
•
for which the matching route would be displayed.
interface-type interface-number
•
Specifies that the routes with next-hops on the selected
interface be displayed.
• best—Specifies that only the best routes are displayed.
If the connected keyword is selected for protocol, the
best option is not available because there are no best or
non-best connected routes.
View detailed information about the IPv6 route
preferences.
—Specifies an IPv6 address for which the
—Specifies the protocol that installed the
—Specifies an IPv6 network
—Valid IPv6 interface.