Ipv6 Routing Commands - Dell N1100-ON Reference Manual

IPv6 Routing Commands

Dell EMC Networking N1500/N2000/N2100-ON/N3000/N3100-
ON/N4000 Series Switches
The Dell Network N1500/N2000/N2100-ON series supports limited routing and
multicast capabilities. See the Users Configuration Guide section "Feature
Limitations and Platform Constants" for supported capabilities.
The IPv6 version of the routing table manager provides a repository for IPv6
routes learned by dynamic routing protocols or static configuration. RTO6
manages dynamic and static IPv6 routes, redistributes routes to registered
protocols, supports ECMP routes, and supports multiple routes to the same
destination, sorted by preference. IPv6 routing only operates over VLAN
interfaces.
IPv6 Limitations & Restrictions
The following limitations apply:
• IPSec support is not available.
• The DHCPv6 server does not support stateful address configuration.
• Automated router renumbering is not supported.
Commands in this Section
This section explains the following commands:
arp
clear ipv6 statistics ipv6 nd ra hop-limit
ipv6 address
ipv6 enable
ipv6 hop-limit
ipv6 nd dad
attempts
unspecified
ipv6 nd managed-
config-flag
ipv6 nd ns-interval ip route distance
ipv6 nd nud max-
multicast-solicits
–
ipv6 nd suppress-ra show ipv6 mld host-
ipv6 route
ipv6 unicast-
routing
Layer 3 Routing Commands
show ipv6 mld host-
proxy groups
proxy groups detail
show ipv6 mld host-
proxy interface
show ipv6 mld traffic
show ipv6 nd raguard
policy
1511