Permit (Management) - Dell PowerConnect 6024F Command Line Interface Reference Manual
Command
line interface (cli) guide (.htm)
Hide thumbs
Also See for PowerConnect 6024F:
- User manual (474 pages) ,
- Getting started manual (66 pages) ,
- Getting started manual (154 pages)
Table of Contents
Advertisement
The following example shows how to create an access-list called "mlist", configure all interfaces to
be management interfaces except interfaces ethernet g1 and ethernet g9, and make the access-list
the active list.
Console (config)# management access-list mlist
Console (config-macl)# deny ethernet g1
Console (config-macl)# deny ethernet g9
Console (config-macl)# permit
Console (config-macl)# exit
Console (config)# management access-class mlist
permit (management)
The permit management access-list configuration command defines a permit rule.
Syntax
permit [ethernet interface-number | vlan vlan-id | port-channel number | out-of-band-eth
oob-interface] [service service]
permit ip-source ip-address [mask mask | prefix-length] [ethernet interface-number | vlan
vlan-id | port-channel number | out-of-band-eth oob-interface] [service service]
•
ethernet interface-number—A valid Ethernet port number.
•
vlan vlan-id—A valid VLAN number.
port-channel number—A valid port channel number.
•
ip-address—Source IP address.
•
•
mask mask—Specifies the network mask of the source IP address.
•
mask prefix-length—Specifies the number of bits that comprise the source IP address
prefix. The prefix length must be preceded by a forward slash (/).
•
service service—Indicates service type. Can be one of the following: telnet, ssh, http,
https or snmp.
•
out-of-band-eth oob-interface—Out-of-band Ethernet port number.
Default Configuration
This command has no default configuration.
Command Mode
Management Access-list Configuration mode
208
Management ACL
Advertisement
Table of Contents
