Rep 10.3 Main/Sub Heater Rod - Xerox DocuColor 2240 Service Manual

REP 10.3 Main/Sub Heater Rod

Parts List on PL 7.2
Removal
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine.
Wait until the Fuser cools down before performing this procedure.
Do not touch the glass surface of the Heater Rod. If the glass is accidentally touched, wipe it
with a dry cloth.
1. Remove the Fuser Assembly (REP
2. Remove the following parts:
• Front Cover (PL 7.2)
• Handle (PL 7.2)
• Rear Cover (PL 7.2)
• Handle (PL 7.2)
3. Disconnect connectors (2) at rear of Fuser
Figure 1 Disconnecting Connectors
Repairs and Adjustments
REP 10.3
WARNING
CAUTION
CAUTION
10.1).
(Figure 1).
Disconnect
connectors
4. Remove Heater Rods (Figure
3
Remove Heat
Rod Support
2
Remove
screw
1
Disconnect
connectors
Figure 2 Removing Heater Rods
02/03
4-100
2).
4
Remove Heater
Rods
DC 3535/2240/1632
Initial issue