Rep 2.0.7 Purge Pressure Pump; Rep 2.0.8 Left And Right Printhead Restraints - Xerox Phaser 8560MFP Service Documentation

REP 2.0.7 Purge Pressure Pump

Parts List on PL 2.0
Removal
1. Remove the Left Side Cover (REP 1.0.7).
2. Disconnect the Purge Pump Hose from the pump.
3. Disconnect the harness from the pump.
4. Remove 3 (plastic, T-20) screws that secure the pump to the chassis.
Figure 1 Removing the Purge Pressure Pump
Initial Issue
Phaser 8510/8560MFP Multifunction Product

REP 2.0.8 Left and Right Printhead Restraints

Parts List on PL 2.0
Removal
When parked, the Printhead is held in place by pins that are captured by left and right Print-
head restraints. If the restraints are released, tension from the Printhead Tilt Spring will force
the Printhead toward the Drum. Gradually release the spring tension when unlocking the Print-
head restraints.
Allow adequate time for the Printhead to cool before servicing the printer.
1. Remove the Scanner Assembly with the attached DADF (REP 1.0.11)
2. Remove the Output Tray (REP 1.0.6)
3. Remove the Right Side Cover (REP 1.0.21)
4. Remove the Left Side Cover (REP 1.0.7)
5. Remove the Ink Loader Assembly (REP 2.0.1)
6. Place several sheets of paper between the Printhead and Drum to protect the Drum.
7. Unlock the Wiper Assembly by raising the Wiper Assembly Lock.
Figure 1 Releasing the Printhead Restraints
8. Lower the Wiper Assembly completely by rotating the drive gear s as shown.
10/2006
4-25
WARNING
Repairs and Adjustments
REP 2.0.7, REP 2.0.8