Vrrp Mode - Dell C9000 Series Reference Manual

1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the ip trace-list command. Include the name of the Trace list. The prompt changes to
include (conf-trace-acl).
You can exit this mode by using the exit command.

VRRP Mode

To enable and configure Virtual Router Redundancy Protocol (VRRP), use VRRP mode. For more information,
see Virtual Router Redundancy Protocol
To enter VRRP mode:
1 To enable VRRP globally, verify that you are logged in to CONFIGURATION mode.
2 Enter the vrrp-group command then enter the VRRP group ID. The prompt changes to include (conf-
if-interface-type-slot/port-vrid-vrrp-group-id).
UPLINK STATE GROUP Mode
To enable and configure an uplink-state group, use UPLINK STATE GROUP mode. For more information, see
Uplink Failure Detection
To enter UPLINK STATE GROUP mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the uplink-state-group command then the group ID number. The prompt changes to include
(conf-uplink-state-group-groupID).
(VRRP).
(UFD).
CLI Basics 66