Debug Ip Bgp Updates - Dell S4810 Reference Manual

Version 7.7.1.0
Version 7.2.1.0
Usage
This command turns on BGP soft-reconfiguration inbound debugging. If no
Information
neighbor is specified, debug turns on for all neighbors.

debug ip bgp updates

Allows you to view information about BGP updates.
S4810
Syntax
debug ip bgp updates [in | out | prefix-list prefix-list-name]
To disable debugging, use the no debug ip bgp [ip-address | peer-group
peer-group-name] updates [in | out] command.
Parameters
in
out
prefix-list
prefix-list-
name
ip-address
peer-group-
name
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Border Gateway Protocol
Introduced on the C-Series.
Introduced.
(OPTIONAL) Enter the keyword in to view only BGP updates
received from neighbors.
(OPTIONAL) Enter the keyword out to view only BGP
updates sent to neighbors.
(OPTIONAL) Enter the keyword prefix-list then the
name of an established prefix list. If the prefix list is not
configured, the default is permit (to allow all routes).
(OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
(OPTIONAL) Enter the name of the peer group to disable or
enable all routers within the peer group.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
413